Min or Max Radius

[FrancoisY]

Hi All,

if a radius has a Max or Min radius call out, is it affected by the general tolerance table in the drawing?

Thank you

 

[jassco]

No. Your general tolerance table only applies to those dimensions that have not tolerance.

Best regards,

Alex

 

[FrancoisY]

No. Your general tolerance table only applies to those dimensions that have not tolerance.

Best regards,

Alex

thank you!

 

[looslib]

Be careful using a min radius. Basically anything larger than the min is allowed. There is no control on it unlike a max which sets a limit.

 

[y2k_o__o]

Call out will overwrite anything in the general tolerance table

Normally I don't control fillet radius unless it's a critical feature to avoid interference or stress concentration.

 

[ShataCastings]

Genral tolerance = Unless specified tolerance
So once you add Max or Min Radius, it was specified