Square shaft design 5

[dejan95]

Hello everybody,

I have a question about designing a square shaft. Picture bellows shows my shaft which is round. At the end (t highlighted part) I would like to make it squere to prevend turning of the part that is attached to it. (unfortunately I don't have enough room for a dowel or a pin).

So this part would probably be made with milling? How do I design it so the operator won't have any problem making this part.

Thank you in advance!

 

[IFRs]

Could the shaft be threaded?

 

[mfgenggear]

Dejan95 where are you lol

 

[Hoonya]

Are you working in solidworks? Or it is an another programm?